|Maximum Fluid Temperature||60 Degree C|
|Voltage||240 V AC|
|Model No||BTALI 13 APC|
|IP Rating||IP 65|
DESCRIPTION: The product can rplace the complicated installations of automatic water pump e.g. pressure gauge, pressure switch, T-valve, check valve and pressure tank. It has the feature fo stable performance. low maintenance and long life etc. It will indicate teh pump has started when the green light power on lights up after connecting teh power. When the yellow light pump on lights up, it indicateds the pump has been started. The pump continues to operate for few minutes enabling the system to fill in the pipes and to reach the required pressure. If this lapse is insufficient the red light failure will light up. In this event, keep the restart button pressed and wait with a tap opened till the red light is off. Once released the button and closed the tap, the product will keep teh pump at its maximum pressure.
• Dry running protection with automatic reset
• Designed for high start/stop per hour
• Built in thermal protection
• Easy to install and silent running
• Low maintenance, extended pump life
• The product is designed especially for all control operation of automatic water pump.
• If the particular breakdwons occur, such as water failure, obstruction of the suction pipe etc.
• The product recognizes the breakdowns and the red light failure lights up at the same a stop signal is sent to the pump to prevent damages caused by its working in the absence of water
• Rectification of the failures that have caused teh blockage allows the system to be restarted by pressing the restart button
• The controller can ensure a constant pressure for the water supplying system and thus reduce the water hammer effect inside pipeling during water delivering
• The controller also passesses the features of reset after power failure
• Its starting flow is about 36-60 l/h and is convenient for home application.
*POWER WIRE - 1.0sqmm*1mtr with 2 pin Heavy Duty 16Amp 2Pin Plug
*Pump wire - 1.0sqmm * 0.5 mtr
* OMRON Relay